DTC P00E0-00: ECT Sensor No. 2 Circuit Low Input
WARNING: This page is about a different variant/trim than selected.
P00E0-00: (PCM - VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
ECT sensor No. 2 circuit low input |
| Detection condition |
- The PCM monitors the ECT sensor No. 2 signal. If the PCM detects that the ECT sensor No. 2 voltage at the PCM terminal 2AD is standard or less, the PCM determines that the ECT sensor No. 2 circuit has a malfunction.
|
| Fail-safe |
- Inhibits the boost control.
|
| Possible cause |
- ECT sensor No. 2 malfunction (Refer to applicable ENGINE COOLANT TEMPERATURE (ECT) SENSOR INSPECTION (VIN Y)
in service information.)
- Malfunction in wiring harness (including connector/terminal) between PCM and ECT sensor No. 2 (see CIRCUIT INSPECTION
.) (see CONNECTOR INSPECTION
.)
- PCM malfunction (Refer to applicable PCM REMOVAL/INSTALLATION (VIN Y)
in the service information.
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (see CLEARING DTC
.)
- Perform the KOEO or KOER self test. (See DTC INSPECTION
.)
|
 Courtesy of MAZDA MOTORS CORP.
|
| 1 |
PCM |
| 2 |
ECT sensor No. 2 |