DTC P0602-00: Pcm Programming Error

WARNING: This page is about a different variant/trim than selected.

P0602-00: (PCM - VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location	PCM programming error
Detection condition	No configuration data in the PCM.
Fail-safe	Not applicable
Possible cause	PCM configuration has not been completed. (see CONFIGURATION .) PCM connector or terminals malfunction (see CONNECTOR INSPECTION .) PCM malfunction (Refer to applicable PCM REMOVAL/INSTALLATION (VIN Y) in the service information.)
Repeatability verification procedure	Clear the DTC recorded in the memory. (see CLEARING DTC .) Perform the KOEO or KOER self test. (See DTC INSPECTION .)
System wiring diagram	Not applicable