Details On DTCs

WARNING: This page is about a different variant/trim than selected.

P050A-00: (PCM - VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location	Cold start IAC system performance problem
Detection condition	Determination conditions	The difference between the actual engine speed and the target engine speed is the standard or more.
	Preconditions	Engine speed: 500 rpm or more^1 Engine coolant temperature: -10-45°C {14-113°F} Catalytic converter estimated temperature: 380°C {716°F} or less* Vehicle speed: 0 km/h {0 mph}^1 The following DTCs are not detected: ECT sensor No. 1 malfunction: P0116-00:, P0117-00: and P0118-00: MAP sensor malfunction: P0107-00: and P0108-00: BARO sensor malfunction: P2226-00:, P2228-00: and P2229-00: Instrument cluster malfunction: P2610-00: : Standard can be verified by displaying PIDs using M-MDS
	Malfunction determination period	9 s period
	Drive cycle	2
	Self test type	CMDTC self test
	Sensor used	CKP sensor ECT sensor No. 1
Fail-safe	Limits intake air amount Stops high pressure fuel pump control
Vehicle status when DTCs are output	Not applicable
Possible cause	Air suction in intake air system Drive-by-wire control system malfunction Throttle valve malfunction PCM malfunction