Intention of troubleshooting procedure

WARNING: This page is about a different variant/trim than selected.

Step 1
- Verify that there is no problem with engagement of each separate part.
Step 2
- Verify the body control module (BCM) installation condition.
Repair completion verification
- Verify that the primary malfunction is resolved and there are no other malfunctions.

U2300:00 (PCM - VIN Y) TROUBLESHOOTING DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	PURPOSE: CHECK BODY CONTROL MODULE (BCM) AND PCM CONNECTORS FOR FAILURE. Check the connectors of the following components: (see CONNECTOR INSPECTION .) Body control module (BCM) PCM Are the connector and terminal normal?	Yes	Go to the next step.
1		No	Repair or replace the malfunctioning location and perform the repair completion verification 1.
2	PURPOSE: TO CHECK FOR INCORRECT INSTALLATION OF BODY CONTROL MODULE (BCM) Verify the body control module (BCM) installation condition. (Refer to applicable BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION in the service information.) Is the installation condition normal?	Yes	Replace the body control module (BCM) and perform the repair completion verification 1. (Refer to applicable BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION in the service information.)
2		No	Correctly install the body control module (BCM) and perform the repair completion verification 1. (Refer to applicable BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION in the service information.)
Repair completion verification 1	PURPOSE: VERIFY THAT VEHICLE IS REPAIRED Install/connect the part removed/disconnected during the troubleshooting procedure. Clear the DTC recorded in the memory. (see CLEARING DTC .) Replicate the vehicle conditions at the time the DTC was detected using the following procedure. Implement the repeatability verification procedure. (See REPEATABILITY VERIFICATION PROCEDURE .) Perform the DTC inspection for the PCM. (See DTC INSPECTION .) Is the same DTC displayed?	Yes	Refer to the CAN (controller area network) malfunction diagnosis flow to inspect for a CAN communication error. (See MALFUNCTION DIAGNOSIS FLOW [CONTROLLER AREA NETWORK (CAN)] .) If the CAN communication is normal, perform the diagnosis from Step 1. If, malfunction is not resolved, replace the PCM, then go to the next step. (Refer to applicable PCM REMOVAL/INSTALLATION (VIN Y) in the service information.)
Repair completion verification 1		No	Go to the next step.
Repair completion verification 2	PURPOSE: VERIFY IF OTHER DTCs ARE DISPLAYED Perform the DTC inspection. (See DTC INSPECTION .) Are other DTCs displayed?	Yes	Repair the, malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [PCM (VIN Y)] .)
Repair completion verification 2		No	DTC troubleshooting completed.