DTC U213D-00: Can Communication System: Communication Error To TCM
WARNING: This page is about a different variant/trim than selected.
U213D:00 (PCM - VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
CAN communication system: Communication error to TCM |
| Detection condition |
- Communication error between the PCM and TCM continues for a specified period of time.
|
| Fail-safe |
- Controls the turbine rotation signal at 0.
- Inhibits the AT torque reduction request.
|
| Possible cause |
- Malfunction in CAN communication line between TCM and PCM
- TCM malfunction (Refer to applicable CONTROL VALVE BODY REMOVAL/INSTALLATION [GW6AX-EL]
in the service information.)
- PCM malfunction (Refer to applicable PCM REMOVAL/INSTALLATION (VIN Y)
in the service information.)
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (see CLEARING DTC
.)
- Replicate the vehicle conditions at the time the DTC was detected using the following procedure.
- Switch the ignition ON (engine on).
- Perform the DTC inspection for the PCM. (See DTC INSPECTION
.)
|
| System wiring diagram |
|