DTC U060F-00: Sent Communication System: Communication Error Between MAF Sensor/IAT Sensor No. 1 And Pcm
WARNING: This page is about a different variant/trim than selected.
U060F:00 (PCM - VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
SENT communication system: Communication error between MAF sensor/IAT sensor No. 1 and PCM |
| Detection condition |
- When any of the following conditions is met:
- SENT communication line malfunction between MAF sensor/IAT sensor No. 1 and PCM
- The PCM detected a SENT communication type communication error from the MAF sensor/IAT sensor No. 1.
|
| Fail-safe |
|
| Possible cause |
- Malfunction in wiring harness (including connector/terminal) between MAF sensor/IAT sensor No. 1 and PCM (see CIRCUIT INSPECTION
.) (see CONNECTOR INSPECTION
.)
- MAF sensor/IAT sensor No. 1 malfunction (Refer to applicable MASS AIR FLOW (MAF) SENSOR/INTAKE AIR TEMPERATURE (IAT) SENSOR NO. 1 REMOVAL/INSTALLATION (VIN Y)
in the service information.)
- PCM malfunction (Refer to applicable PCM REMOVAL/INSTALLATION (VIN Y)
in the service information.)
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (see CLEARING DTC
.)
- Perform the KOEO or KOER self-test. (See DTC INSPECTION
.)
|
 Courtesy of MAZDA MOTORS CORP.
|
| 1 |
MAF sensor/IAT sensor No. 1 |
| 2 |
PCM |