Details On DTCs

WARNING: This page is about a different variant/trim than selected.

P250F:00 (PCM - VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location	Engine oil level signal: Engine oil level low
Detection condition	Determination conditions	The engine oil level has decreased around or below MIN mark.
	Preconditions	Engine speed: 600-2, 000 rpm^1 Vehicle speed: 5 km/h {3 mph} or more^1 Engine oil control: During low oil pressure Engine oil temperature: 20-90°C {68-194°F}^1 G at front and back of vehicle: 0.2 G or less G at left and right sides of vehicle: 0.2 G or less The following DTCs are not detected: Communication error between engine oil level sensor and PCM: U1100:00 Engine oil level sensor: P250A:00 and P250C:00 ^1 : Standard can be verified by displaying PIDs using M-MDS
	Malfunction determination period	Not applicable
	Drive cycle	1
	Self test type	CMDTC self test
	Sensor used	PCM Engine oil level sensor Engine oil temperature sensor Low-G sensor (built-into SAS control module)
Fail-safe	Not applicable
Vehicle status when DTCs are output	Not applicable
Possible cause	Improper engine oil level (low) Engine oil leakage Engine oil level sensor malfunction Clogging of oil passage to engine oil level sensor detection area Engine oil level sensor internal application specific integrated circuit malfunction Erratic signal to PCM Engine oil level sensor connector or terminals malfunction Open circuit in engine oil level sensor LIN communication line PCM malfunction