Intention of troubleshooting procedure

WARNING: This page is about a different variant/trim than selected.

Step 1
- Inspect the LIN communication line of the engine oil level sensor.
Repair completion verification
- Verify that the primary malfunction is resolved and there are no other malfunctions.

P250A:00 (PCM - VIN Y) TROUBLESHOOTING DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	PURPOSE: INSPECT WIRING HARNESS (INCLUDING CONNECTOR/TERMINAL) BETWEEN ENGINE OIL LEVEL SENSOR AND PCM FOR MALFUNCTION Inspect the applicable circuit. (see CIRCUIT INSPECTION .) (see CONNECTOR INSPECTION .) Is the circuit normal?	Yes	Replace the engine oil level sensor and perform the repair completion verification 1. (Refer to applicable ENGINE OIL LEVEL SENSOR REMOVAL/INSTALLATION (VIN Y) in the service information.)
1		No	Repair or replace the malfunctioning location and perform the repair completion verification 1.
Repair completion verification 1	PURPOSE: VERIFY THAT VEHICLE IS REPAIRED Install/connect the part removed/disconnected during the troubleshooting procedure. Clear the DTC recorded in the memory. (see CLEARING DTC .) Replicate the vehicle conditions at the time the DTC was detected using the following procedure. Implement the repeatability verification procedure. (See REPEATABILITY VERIFICATION PROCEDURE .) Perform the DTC inspection for the PCM. (See DTC INSPECTION .) Is the same Pending DTC present?	Yes	Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See MALFUNCTION DIAGNOSIS FLOW [CONTROLLER AREA NETWORK (CAN)] .) If the CAN communication is normal, perform the diagnosis from Step 1. If the malfunction recurs, replace the PCM, then go to the next step. (Refer to applicable PCM REMOVAL/INSTALLATION (VIN Y) in the service information.)
Repair completion verification 1		No	Go to the next step.
Repair completion verification 2	PURPOSE: VERIFY IF OTHER DTCs DISPLAYED Perform the DTC inspection. (See DTC INSPECTION .) Are any other DTCs displayed?	Yes	Repair or replace the malfunctioning location according to the applicable DTC troubleshooting.
Repair completion verification 2		No	DTC troubleshooting completed.