DTC P2302-00: Ion Sensor No. 1: Circuit Problem
WARNING: This page is about a different variant/trim than selected.
P2302:00 (PCM - VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
Ion sensor No. 1: circuit problem |
| Detection condition |
- After the engine is started, when the engine speed is standard or less, the signal input to the PCM from ion sensor No. 1 is in error.
|
| Fail-safe |
|
| Possible cause |
- Cylinder No. 1 misfire (See P0301-00:
.)
- Malfunction in wiring harness (including connector/terminal) between main relay and ignition coil/ion sensor No. 1 (see CIRCUIT INSPECTION
.) (see CONNECTOR INSPECTION
.)
- Malfunction in wiring harness (including connector/terminal) between ignition coil/ion sensor No. 1 and PCM (see CIRCUIT INSPECTION
.) (see CONNECTOR INSPECTION
.)
- Ion sensor No. 1 malfunction (Refer to ION SENSOR INSPECTION (VIN Y)
in the service information.)
- PCM malfunction (Refer to applicable PCM REMOVAL/INSTALLATION (VIN Y)
in the service information.)
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (see CLEARING DTC
.)
- Perform the KOER self test. (See DTC INSPECTION
.)
|
 Courtesy of MAZDA MOTORS CORP.
|
| 1 |
Battery |
| 2 |
Main relay |
| 3 |
Ignition coil/ion sensor No. 1 |
| 4 |
PCM |