Function Inspection Using M-MDS
WARNING: This page is about a different variant/trim than selected.
P0089:00 (PCM - VIN Y) FUNCTION INSPECTION USING M-MDS
| Step | Inspection | Results | Action |
|---|---|---|---|
| 1 | PURPOSE: IDENTIFY TRIGGER DTC FOR FREEZE FRAME DATA
|
Yes | Go to the next step. |
| No | Go to the troubleshooting procedure for DTC on freeze frame data. (See DTC TABLE [PCM (VIN Y)] .) |
||
| 2 | PURPOSE: RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
|
- | Go to the next step. |
| 3 | PURPOSE: INSPECT FOR OTHER RELATED DTCs
|
Yes | Repair or replace the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [PCM (VIN Y)] .) Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 1. |
| No | Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 1. |