DTC P007B-00: Boost Air Temperature Sensor Circuit Range/Performance Problem
WARNING: This page is about a different variant/trim than selected.
P007B:00 (PCM - VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
Boost air temperature sensor circuit range/performance problem |
| Detection condition |
U.S.A. and CANADA:
- The condition has continued in which difference in intake air temperature measured by the boost air temperature sensor and IAT sensor No. 1 or No. 2 is not within the specification
Precondition
- Period vehicle being left: 6 h or more
- Battery voltage: 8 V or more
- Within 20 s after engine start
- The following DTCs are not detected:
- Boost air temperature sensor: P007C:00 and P007D:00
- IAT sensor No. 1: P0110:00 and U060F:00
- IAT sensor No. 2: P0097:00 and P0098:00
Precondition
- Period vehicle being left: 6 h or more
- Battery voltage: 8 V or more
- Within 20 s after engine start
- The following DTCs are not detected:
- Boost air temperature sensor: P007C:00 and P007D:00
- IAT sensor No. 1: P0110:00 and U060F:00
- IAT sensor No. 2: P0097:00 and P0098:00
|
| Fail-safe |
|
| Possible cause |
- Boost air temperature sensor malfunction (Refer to BOOST AIR TEMPERATURE SENSOR INSPECTION (VIN Y)
in the service information.)
- Malfunction in wiring harness (including connector/terminal) between PCM and boost air temperature sensor (see CIRCUIT INSPECTION
.) (see CONNECTOR INSPECTION
.)
- PCM malfunction (Refer to applicable PCM REMOVAL/INSTALLATION (VIN Y)
in the service information.)
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (see CLEARING DTC
.)
- Perform the KOEO or KOER self test. (See DTC INSPECTION
.)
|
Courtesy of MAZDA MOTORS CORP.
|
| 1 |
PCM |
| 2 |
Boost air temperature sensor |