LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (On-Board Diagnostic - Engine Control (VIN Y) (1 Of 6)) >> DTC B10A2-00: Vehicle Collision Determination System: Vehicle Collision >> Repeatability Verification Procedure

Repeatability Verification Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Switch the ignition ON and leave for 5 s or more.
  2. Clear the DTC recorded in the PCM memory using the M-MDS. (see CLEARING DTC .)
  3. After switching the ignition off, switch the ignition back ON and leave for 5 s or more.
  4. Using the M-MDS, display DTCs and verify that DTC U0151:00 is not displayed. (See DTC INSPECTION .)
scientia non olet · About LEMON Manuals