U.S.A. and CANADA
WARNING: This page is about a different variant/trim than selected.
- Remove the pressure control valve. (See PRESSURE CONTROL VALVE REMOVAL/INSTALLATION (VIN Y) .)CAUTION:
- Do not apply a pressure 0.3 kPa {0.003 kgf/cm2, 0.04 psi} or more. Doing so will damage the pressure control valve and evaporative hose.
- Apply a pressure of 0.3 kPa {0.003 kgf/cm2, 0.04 psi} to port A.
- Verify that there is airflow from port B.
- If there is no airflow, replace the pressure control valve.