Continuity Inspection
WARNING: This page is about a different variant/trim than selected.
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
- Remove the three way solenoid valve. (See THREE WAY SOLENOID VALVE REMOVAL/INSTALLATION (VIN Y) .)
- Inspect airflow between the ports under the following conditions.
| Measured condition | Continuity between nipples A-B | Continuity between nipples B-C | Continuity between nipples A-C |
|---|---|---|---|
| When voltage is not applied | No airflow | Airflow detected | No airflow |
| When voltage is applied | Airflow detected | No airflow | No airflow |
- If not as specified, replace the three way solenoid valve. (See THREE WAY SOLENOID VALVE REMOVAL/INSTALLATION (VIN Y) .)