Intake Manifold Vacuum Inspection (VIN Y)

WARNING: This page is about a different variant/trim than selected.

Remove the check valve (intake-air system) and install the vacuum gauge. (See CHECK VALVE (EMISSION SYSTEM) REMOVAL/INSTALLATION (VIN Y) .)
Verify that the intake air hoses are installed securely.
Warm up the engine.
Measure the intake manifold vacuum while idling (no load) using the vacuum gauge.
- If not within the specification, perform the following inspections.
  - Compression pressure (See COMPRESSION INSPECTION (VIN Y) .)
  - Check valve (intake-air system) (See CHECK VALVE (INTAKE-AIR SYSTEM) REMOVAL/INSTALLATION (VIN Y) .)
  - Check valve (intake manifold side) (See CHECK VALVE (EMISSION SYSTEM) REMOVAL/INSTALLATION (VIN Y) .)
  - Air suction
    - Installation areas of each vacuum hose
    - Installation area of dynamic pressure turbo
    - Installation area of water-cooled charge air cooler
    - Installation area of throttle body
    - Installation area of fuel injector
    - Installation area of PCV valve
    - Installation area of intake manifold
  Standard
  
  Approx. -60.0 kPa {-450.0 mmHg, -17.7 inHg}