Plug Gap Inspection

WARNING: This page is about a different variant/trim than selected.

CAUTION:

To avoid possible damage to the tip, do not adjust the plug gap.
To prevent damaging the tip, use a wire type plug gap gauge when inspecting the plug gap.

Measure the spark plug gap using a wire type plug gap gauge.
- If not within the standard specification, replace the spark plug.
  Spark plug gap
  
  Standard: 0.70-0.85 mm {0.028-0.033 in}
  
  New spark plug (reference): 0.70-0.80 mm {0.028-0.031 in}