LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical System (VIN Y)) >> Timing Chain Removal/Installation (VIN Y) >> No. 3 Engine Mount Installation Note

No. 3 Engine Mount Installation Note

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • If the No. 3 engine mount is deviated from the original position when installing the No. 3 engine mount, engine noise or vibration could increase. When installing the No. 3 engine mount, align the alignment mark placed during removal and install it to the original position.
NOTE:
  • When replacing the No. 3 engine mount, place a mark at the same position as the one placed before removal.
  • If the No. 3 engine mount nut is loosened, tighten the engine front cover stud bolts because they may have loosened.
  1. Install the No. 3 engine mount. (See NO. 3 ENGINE MOUNT DISASSEMBLY/ASSEMBLY (VIN Y)  .)
  2. Remove the SST.
  3. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals