LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical System (VIN Y)) >> Plug Hole Plate Removal/Installation (VIN Y) >> Removal

Plug Hole Plate Removal/Installation (VIN Y): Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • When removing the plug hole plate, pull it straight up. If the plug hole plate contacts the fuel hose at the position shown in the figure, the fuel hose could be damaged.
G16379687Courtesy of MAZDA MOTORS CORP.
  1. Pull up the front part of the plug hole plate at the same time and remove the rubber and adapter from the engine side.
    G16379688Courtesy of MAZDA MOTORS CORP.
  2. Pull up the plug hole plate in the order shown in the figure and remove the adapter from the rubber on the engine side.
    G16379689Courtesy of MAZDA MOTORS CORP.