LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical System (VIN Y)) >> Engine Tune-Up (VIN Y) >> Engine Tune-up Preparation

Engine Tune-up Preparation

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • If the accelerator pedal is depressed continuously for a specified time, the engine speed may decrease to the idle speed. This is due to the fuel cut control operation, which prevents overheating, and it does not indicate a malfunction. The engine speed returns to normal control when the accelerator pedal is released.
  1. Connect the M-MDS to the DLC-2.
  2. Shift the selector lever to the P position or N position.
    NOTE:
    • The engine coolant temperature and oil temperature can be verified by M-MDS PCM PID [ECT] and [OIL_TEMP].
  3. Run the engine speed at a constant 2, 500 to 3, 000 rpm and warm up the engine (engine coolant temperature: 80°C {176°F} or more, oil temperature: 60°C {140°F} or more).
  4. Turn off all electrical loads with the engine idling.
  5. If the cooling fan is operating, wait until is stops.
scientia non olet · About LEMON Manuals