LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical System (VIN Y)) >> Engine Mount Disassembly/Assembly (VIN Y) >> No. 4 Engine Mount >> No. 4 engine mount rubber removal note

No. 4 engine mount rubber removal note

WARNING: This page is about a different variant/trim than selected.
  1. Before removing the No. 4 engine mount rubber, support the transaxle using a commercially available engine lifter or garage jack.
  2. Place alignment marks on the locations shown in the figure so that they can be assembled to the same positions as before removal.
    G16379592Courtesy of MAZDA MOTORS CORP.
    NOTE:
    • Paint so that the outline of the nut is framed on the bracket side.
  3. Remove the No. 4 engine mount rubber.
scientia non olet · About LEMON Manuals