LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical System (VIN Y)) >> Engine Mount Disassembly/Assembly (VIN Y) >> No. 4 Engine Mount >> No. 4 engine mount bracket removal note

No. 4 engine mount bracket removal note

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • To prevent damage to the transaxle, support the transaxle using the following methods.
    • Place rubber of appropriate size (approx. 20 mm {0.79 in} thickness) on a batten which is large enough to cover and support the oil pan.
G16379590Courtesy of MAZDA MOTORS CORP.
  1. Place alignment marks on the locations shown in the figure so that they can be assembled to the same positions as before removal.
    G16379591Courtesy of MAZDA MOTORS CORP.
    NOTE:
    • Paint so that the outline of the nut is framed on the bracket side.
  2. Before removing the No. 4 engine mount bracket, support the transaxle using a commercially available engine lifter or garage jack.
  3. Remove the No. 4 engine mount bracket.
scientia non olet · About LEMON Manuals