LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical System (VIN Y)) >> Engine Mount Disassembly/Assembly (VIN Y) >> No. 1 Engine Mount >> No. 1 engine mount installation note

No. 1 engine mount installation note

WARNING: This page is about a different variant/trim than selected.
  1. Tighten the No. 1 engine mount bracket installation bolts in the order shown in the figure.
    Fig 1: No. 1 Engine Mount Bracket Installation Bolts Tightening Sequence
    G16379578Courtesy of MAZDA MOTORS CORP.
  2. Temporarily tighten the No. 1 engine mount rubber installation bolts in the order shown in the figure.
    Fig 2: No. 1 Engine Mount Rubber Installation Bolts Tightening Sequence
    G16379579Courtesy of MAZDA MOTORS CORP.
  3. Tighten the No. 1 engine mount rubber installation bolts in the order shown in the figure.
    Fig 3: No. 1 Engine Mount Rubber Installation Bolts Tightening Sequence
    G16379580Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals