LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical System (VIN Y)) >> Electric Variable Valve Timing Actuator, Hydraulic Variable Valve Timing Actuator Removal/Installation (VIN Y) >> Hydraulic Variable Valve Timing Actuator Installation Note

Hydraulic Variable Valve Timing Actuator Installation Note

WARNING: This page is about a different variant/trim than selected.
  1. When replacing the hydraulic variable valve timing actuator, place a mark at the same position as the one placed before removal.
  2. Align the knock pin on the end of the exhaust camshaft with the knock pin installation hole on the actuator side, and temporarily assemble the bolt.
    G16379546Courtesy of MAZDA MOTORS CORP.
  3. Lock the exhaust camshaft against rotation by holding the exhaust camshaft with a vise and securing the cast hexagon with a wrench.
    G16379547Courtesy of MAZDA MOTORS CORP.
  4. Tighten the hydraulic variable valve timing actuator installation bolt.
scientia non olet · About LEMON Manuals