LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical System (VIN Y)) >> Cylinder Head Gasket Replacement (VIN Y) >> Flange and Water Inlet Pipe Installation Note

Flange and Water Inlet Pipe Installation Note

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Do not apply oil (such as engine oil, ATF) to the O-ring of the water inlet pipe. Otherwise, the O-ring could swell causing a seal malfunction.
  • Do not apply oil (such as engine oil, ATF) to the gasket of the flange. Otherwise, the gasket could swell causing a seal malfunction.
  1. Apply engine coolant to the O-ring.
  2. Install the O-ring to the water inlet pipe.
  3. Insert the water inlet pipe into the water pump and flange being careful not to damage the O-ring.
  4. Tighten the bolts in the order shown in the figure.
    G16379504Courtesy of MAZDA MOTORS CORP.
  5. Connect the hoses shown in the figure.
    G16379505Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals