Cylinder Head Cover Removal/Installation (VIN Y): Notes
WARNING: This page is about a different variant/trim than selected.
Replacement Part
| Cylinder head cover gasket Quantity: 1 Location of use: Cylinder head cover |
Oil and Chemical Type
| Silicone sealant Type: TB1217D or equivalent |
WARNING:
- A hot engine can cause severe burns. Turn off the engine and wait until it is cool before servicing.
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
- Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION (VIN Y) .)
- Remove the ignition coil/ion sensors. (See IGNITION COIL/ION SENSOR REMOVAL/INSTALLATION (VIN Y) .)
- Remove in the order indicated in the table.
- Install in the reverse order of removal.
- Start the engine and inspect the following:
- Leakage of engine oil.
U.S.A. and CANADA