Function inspection
WARNING: This page is about a different variant/trim than selected.
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Display the PCM PID [IAT2]. (Refer to PID/DATA MONITOR INSPECTION .) .) (Refer to PID/DATA MONITOR TABLE [PCM(VIN Y)] .) .)
- Compare the voltage and temperature indications for the PID [IAT2] with the standard in the table indicated below.
- If they do not match the standard, perform the resistance inspection. (See RESISTANCE INSPECTION .)
VOLTAGE SPECIFICATION - STANDARDIAT2 V °C {°F} Approx. 3.57 20 {68} Approx. 2.70 40 {104} Approx. 1.87 60 {140}