Function inspection
WARNING: This page is about a different variant/trim than selected.
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Display the PCM PID [IAT]. (Refer to PID/DATA MONITOR INSPECTION .) .) (Refer to PID/DATA MONITOR TABLE [PCM(VIN Y)] .) .)
- Compare the voltage and temperature indications for the PID [IAT] with the standard in the table indicated below.
- If they do not match the standard, replace the MAF sensor/IAT sensor No. 1. (See MASS AIR FLOW (MAF) SENSOR/INTAKE AIR TEMPERATURE (IAT) SENSOR NO. 1 REMOVAL/INSTALLATION (VIN Y) .)
VOLTAGE SPECIFICATION - STANDARD
| IAT | |
|---|---|
| V | °C {°F} |
| Approx. 0.36 | 20 {68} |
| Approx. 0.46 | 40 {104} |
| Approx. 0.55 | 60 {140} |