Function Inspection
WARNING: This page is about a different variant/trim than selected.
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Display the PCM PIDs [APP1] and [APP2]. (Refer to PID/DATA MONITOR INSPECTION .) .)
- (Refer to PID/DATA MONITOR TABLE [PCM(VIN Y)] .) .)
- Compare the voltage and opening angle indications for the PIDs [APP1] and [APP2] with the standard in the table indicated below.
- If they do not match the standard, perform the voltage inspection. (See VOLTAGE INSPECTION .)
VOLTAGE SPECIFICATION - STANDARD
| Condition/ | APP1 | APP2 | ||
|---|---|---|---|---|
| V | % | V | % | |
| Accelerator pedal released | Approx. 0.75 | Approx. 15 | Approx. 2.26 | Approx. 45.49 |
| Accelerator pedal depressed | Approx. 4.52 | Approx. 90.58 | Approx. 0.38 | Approx. 7.45 |