LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Cooling System (VIN Y)) >> Water Pump Removal/Installation (VIN Y) >> Water Pump Pulley Installation Note

Water Pump Pulley Installation Note

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Be careful not to damage the belt groove and surface of the water pump pulley when using tools, otherwise it will cause wear, breakage, abnormal noise of the drive belt (stretch belt), damage to the pulley, and rust.
  1. Install the water pump pulley to the water pump and temporarily tighten the bolts.
  2. Align the water pump pulley hole with the water pump hole as shown in the figure.
    G16371863Courtesy of MAZDA MOTORS CORP.
  3. Insert an appropriate bolt (length 55 mm {2.2 in}) into the water pump hole shown in the figure and lock the water pump pulley against rotation.
    G16371864Courtesy of MAZDA MOTORS CORP.
  4. Completely tighten the water pump pulley bolt to the specified torque.
  5. Remove the bolt used for locking the water pump pulley against rotation.
scientia non olet · About LEMON Manuals