Coolant Reserve Tank Removal/Installation (VIN Y): Notes

WARNING: This page is about a different variant/trim than selected.

Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Remove the clip and bolt shown in the figure and set the ground cable aside.

Fig 1: Ground Cable Bolt With Torque Specification
Courtesy of MAZDA MOTORS CORP.
Remove the bolt.

Fig 2: Bracket Bolt With Torque Specification
Courtesy of MAZDA MOTORS CORP.
Remove the bolts shown in the figure and set aside the PCM wiring harness to the engine upper side.

Fig 3: PCM Wiring Harness To Engine Upper Side Bolts With Torque Specification
Courtesy of MAZDA MOTORS CORP.
Remove the nut.

Fig 4: Bracket Nut With Torque Specification
Courtesy of MAZDA MOTORS CORP.
Remove in the order indicated in the table.
Install in the reverse order of removal.

Fig 5: Coolant Reserve Tank Components Location With Torque Specification

Courtesy of MAZDA MOTORS CORP.

COOLANT RESERVE TANK COMPONENT OPERATIONS

Component No	Refer to
1	Bracket
2	Bracket
3	Hose
4	Coolant reserve tank (See COOLANT RESERVE TANK REMOVAL NOTE .)