LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior Trim >> Lower Panel Removal/Installation >> Driver-side

Lower Panel Removal/Installation: Driver-side

  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Driver-side front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Driver-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
    3. Driver-side decoration panel (See DRIVER-SIDE DECORATION PANEL REMOVAL/INSTALLATION  .)
    4. Passenger-side decoration panel (See PASSENGER-SIDE DECORATION PANEL REMOVAL/INSTALLATION  .)
  3. Partially peel back the seaming welt.
    G16376933Courtesy of MAZDA MOTORS CORP.
  4. Remove the bolt.
    Fig 1: Driver-Side Lower Panel And Bolt With Torque Specification
    G16376934Courtesy of MAZDA MOTORS CORP.
  5. Move the driver-side lower panel in the order of arrows (1), (2), (3) and (4) shown in the figure, and remove the clips, hook, tab, and guide.
    G16376935Courtesy of MAZDA MOTORS CORP.
  6. While pressing the hood release lever in the direction of arrow (1) shown in the figure, press the tab in the direction of arrow (2) and detach the tab from the driver-side lower panel.
    G16376936Courtesy of MAZDA MOTORS CORP.
  7. Remove the hood release lever in the direction of arrow (3) shown in the figure.
  8. Disconnect the cluster switch connectors.
    G16376937Courtesy of MAZDA MOTORS CORP.
  9. Remove the data link connector.
  10. Remove the wiring harness clip.
  11. Install in the reverse order of removal.
NOTE:
scientia non olet · About LEMON Manuals