LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> 3 Premium >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim >> Cowl Grille Removal/Installation

Cowl Grille Removal/Installation

  1. Remove the windshield wiper arm and blade. (See WINDSHIELD WIPER ARM AND BLADE REMOVAL/INSTALLATION .)
  2. Disconnect the joint pipe A of the windshield washer hose. (See WINDSHIELD WASHER HOSE REMOVAL/INSTALLATION .)
  3. Remove the clips.
    G13179217Courtesy of MAZDA MOTORS CORP.
  4. Remove the clips. (when removing the weatherstrip)
    G13179218Courtesy of MAZDA MOTORS CORP.
  5. Remove the weatherstrip. (when removing the weatherstrip)
  6. Remove the fasteners.
    G13179219Courtesy of MAZDA MOTORS CORP.
  7. Detach the pins.
  8. Pull the cowl grille in the direction of the arrow in the order of (1), (2), (3), (4), (5) and remove it while detaching the tabs.
    G13179220Courtesy of MAZDA MOTORS CORP.
  9. When removing the side cowl grille, perform the following procedure:
    1. Remove the windshield wiper de-icer wiring harness from the hooks. (with windshield wiper de-icer)
      G13179221Courtesy of MAZDA MOTORS CORP.
    2. Pull the tabs in the direction of the arrow shown in the figure below and detach the tabs from the dashboard upper panel.
      G13179222Courtesy of MAZDA MOTORS CORP.
    3. Pull the side cowl grille in the direction of the arrow shown in the figure below while pulling out the pin.
      G13179223Courtesy of MAZDA MOTORS CORP.
    4. Remove the side cowl grille in the direction of the arrow shown in the figure below while detaching the clip from the dashboard upper panel.
    G13179224Courtesy of MAZDA MOTORS CORP.
  10. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals