Connected Service is not contracted
NOTE:
- DTC U2050:55 is displayed if the activating remote control by smart phone is not implemented. If only DTC U2050:55 is displayed, continue to perform the procedure as indicated as this does not indicate an improper procedure.
- Perform the telematics communication unit configuration using the M-MDS. (Refer to [CONFIGURATION] in the service information.)
- Cancel connected services disable mode. (When transitioning to connected services disable mode) (See SERVICE CAUTIONS FOR VEHICLES WITH TELEMATICS COMMUNICATION SYSTEM .)
- Cancel connected vehicle maintenance mode. (When transitioning to connected vehicle maintenance mode) (See SERVICE CAUTIONS FOR VEHICLES WITH TELEMATICS COMMUNICATION SYSTEM .)
- Perform the activating remote control by smart phone. (See ACTIVATING REMOTE CONTROL BY SMART PHONE .)
- Perform the telematics communication unit initial setting. (See TELEMATICS COMMUNICATION UNIT INITIAL SETTING .)