Connected Service is contracted

NOTE:

DTC U2050:55 is displayed if the activating remote control by smart phone is not implemented. If only DTC U2050:55 is displayed, continue to perform the procedure as indicated as this does not indicate an improper procedure.

Perform the telematics communication unit configuration using the M-MDS. (Refer to [CONFIGURATION] in the service information.)
Cancel connected services disable mode. (When transitioning to connected services disable mode) (See SERVICE CAUTIONS FOR VEHICLES WITH TELEMATICS COMMUNICATION SYSTEM .)
Cancel connected vehicle maintenance mode. (When transitioning to connected vehicle maintenance mode) (See SERVICE CAUTIONS FOR VEHICLES WITH TELEMATICS COMMUNICATION SYSTEM .)
Perform the activating remote control by smart phone. (See ACTIVATING REMOTE CONTROL BY SMART PHONE .)
Perform the telematics communication unit initial setting. (See TELEMATICS COMMUNICATION UNIT INITIAL SETTING .)
Switch the ignition OFF and wait for 5 min or more.
NOTE:
- It takes approx. 5 min to complete the communication processing for the telematics communication system.
Switch the ignition ON (engine off or on) and wait for 1 min or more.
NOTE:
- It takes approx. 1 min to complete the communication processing for the telematics communication system.
Launch the diagnostic assist function. (Refer to the [DIAGNOSTIC ASSIST FUNCTION [CONNECTIVITY MASTER UNIT]] in the service information.)
Select [Service Information] on the diagnostic assist function initial screen.
Select [TCU Linked Information] on the [Service Information] screen.
Verify that the remote service flag in the [Remote Service Flag Information] indicates [1] as shown in the figure below.

Courtesy of MAZDA MOTORS CORP.
Switch the ignition OFF.