LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> 3 Premium >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation/Driver Info >> Notification And Warning Speaker Removal/Installation >> Rear (4SD) >> Notes

Rear (4SD): Notes

  1. Switch the ignition ON (engine off or on).
  2. Open the front driver-side door.
  3. Switch the ignition off.
  4. Disconnect the negative battery terminal and wait for 1 min or more. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  5. Remove the following parts:
    1. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    2. C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION .)
    3. Rear seat cushion (See REAR SEAT CUSHION REMOVAL/INSTALLATION .)
    4. Rear center seat belt anchor (See REAR BUCKLE REMOVAL/INSTALLATION .)
    5. Rear seat back (See REAR SEAT BACK REMOVAL/INSTALLATION .)
    6. Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
    7. Rear package trim (See REAR PACKAGE TRIM REMOVAL/INSTALLATION .)
  6. Remove the bolts. (See BOLT INSTALLATION NOTE .)
    Fig 1: Notification And Warning Speaker Bolts With Torque Specifications
    G14584492Courtesy of MAZDA MOTORS CORP.
  7. Disconnect the connector.
    G14584493Courtesy of MAZDA MOTORS CORP.
  8. Remove the notification and warning speaker (rear).
  9. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals