Indicator Light Illumination Inspection
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
- Remove the front map light. (See FRONT MAP LIGHT REMOVAL/INSTALLATION .)
- Prepare three dry cell batteries (1.5 V).
- Connect the three dry cell batteries in a series.
- Connect the positive pole of the dry cell battery and the negative pole of the dry cell battery to each terminal of the emergency call switch as indicated in the table below, and verify that each LED turns on normally.INDICATOR LIGHT ILLUMINATION INSPECTION DESCRIPTION
Dry cell battery positive pole terminal Dry cell battery negative pole terminal Condition Indicator light (red) Indicator light (green) G B Turns ON Turns OFF F B Turns OFF Turns ON - If the LED does not illuminate, replace the emergency call switch. (See EMERGENCY CALL SWITCH REMOVAL/INSTALLATION .)