Details On DTCs

P0736-00: (SAS) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location	Sensor zero point correction for vehicle rollover detection not implemented
Detection condition	Determination conditions	WARNING: Detection conditions are for understanding the DTC outline before performing an inspection. Performing an inspection only under the detection conditions may cause injury or damage the system due to a mis-operation. When performing an inspection, always follow the diagnostic procedure. The SAS control module detects that the low-G sensor initial setting was not performed.
	Preconditions	Not applicable
	Determination period	Not applicable
Fail-safe	Not applicable
Vehicle status when DTCs are output	Not applicable
Possible cause	Low-G sensor initial setting was not performed. DTCs are stored in the SAS control module. SAS control module malfunction