CD player/DVD/CD player inspection
- Launch the diagnostic assist function. (See ACTIVATION PROCEDURE .)
- Select in the following order from the diagnostic assist function initial screen.
- [Functional Inspection/Adjustment]
- [CD Test]
- Insert a CD into the CD player/DVD/CD player.
- Inspect the CD player or DVD/CD player according to the following table.
-: Not applicable
CD PLAYER/DVD/CD PLAYER INSPECTIONIndication on center display Content Action OK CD player or DVD/CD player is normal - As a result of the inspection, no malfunction was detected.
- Mechanical Coupling Failed CD player or DVD/CD player mechanical malfunction - Disc was unable to load normally due to a problem with the disc (CD or DVD) or a malfunction with the CD player or DVD/CD player.
Verify that the disc (CD or DVD) is not damaged or deformed.
If there is a malfunction:- Perform the inspection again using a normal disc (CD or DVD).
If there is no malfunction:- Refer to [CD PLAYER REMOVAL/INSTALLATION] or [DVD/CD PLAYER REMOVAL/INSTALLATION] in the service information, and replace the CD player or DVD/CD player.
Invalid Signal CD player or DVD/CD player signal error - The disc (CD or DVD) is loaded, but the CD player or DVD/CD player detects an unreadable disc.
Replace with a playable disc (CD or DVD) and perform the inspection again. NOTE:- The playable data format is Music data (CDDA)/MP3/WMA (Windows Media Audio)/AAC (Advanced Audio Coding)/DVD VIDEO/DVDVR.
- Ends the diagnostic assist function. (See ENDING PROCEDURE .)