AM/FM radio information verification

Launch the diagnostic assist function. (See ACTIVATION PROCEDURE .)
Select in the following order from the diagnostic assist function initial screen.
1. [Functional Inspection/Adjustment]
2. [Radio Test Mode AM] or [Radio Test Mode FM]

Rotate the commander knob to switch the frequency and verify the following information.

-: Not applicable

AM/FM RADIO INFORMATION VERIFICATION

Indication on center display	Unit	Content/function
Split Mode ON/OFF	-	Displays on the center display, but does not operate.
Band Type	AM (MW)/AM (LW)/FM	Displays on the center display, but does not operate.
Reception Level	dB	[M]: Indicates the main tuner reception level. [S]: Indicates the sub-tuner reception level.
Destination	-	Displays on the center display, but does not operate.
Operation Status	M	Displays on the center display, but does not operate.
	S	Displays on the center display, but does not operate.
	M+S	Displays on the center display, but does not operate.
RDS BER	-	Displays on the center display, but does not operate.
SNR	-	Displays on the center display, but does not operate.
Total No. of Presets	-	Displays on the center display, but does not operate.
HD Function	Equipped/Not Equipped	Displays on the center display, but does not operate.
VOL	-	Displays on the center display, but does not operate.
Split Mode	ON/OFF	Displays on the center display, but does not operate.
Blend Mode	AUTO/ANALOG/DIGITAL	Displays on the center display, but does not operate.
HD Mode	ON/OFF	Displays on the center display, but does not operate.

Ends the diagnostic assist function. (See ENDING PROCEDURE .)