Diagnostic Procedure
DTC B1A33-49: (CONNECTIVITY MASTER UNIT) DIAGNOSTIC PROCEDURE
| Step | Inspection | Results | Action |
|---|---|---|---|
| 1 | INSPECT REMOTE TUNER (RT) FOR MALFUNCTION
|
Yes | Replace the remote tuner (RT) and perform the repair completion verification. (Refer to the REMOTE TUNER (RT) REMOVAL/INSTALLATION in the service information) |
| No | Verify that the repairs have been completed. | ||
| Repair completion verification 1 | VERIFY THAT VEHICLE IS REPAIRED
|
Yes | Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (Refer to the MALFUNCTION DIAGNOSIS FLOW [CONTROLLER AREA NETWORK (CAN)] in the service information) If the CAN communication is normal, perform the diagnosis from Step 1.
|
| No | Go to the next step. | ||
| Repair completion verification 2 | VERIFY IF OTHER DTCs ARE DISPLAYED
|
Yes | Repair the malfunctioning location according to the applicable DTC troubleshooting. |
| No | DTC troubleshooting completed. |