Connector Inspection
CAUTION:
<<High voltage>>
CAUTION:
- The high voltage circuit inspection differs from the 12 V circuit inspection method. Perform the inspection according to the high voltage service cautions.
- Disconnect the negative battery terminal/negative lead-acid battery terminal. (Refer to [NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION ] ).
- Disconnect the applicable connector.NOTE:
- For the connector disconnection procedure, refer to the removal/installation procedure for each part.
- Inspect the applicable connector for the following: (Refer to [ELECTRICAL SYSTEM
]
).
- Connector engagement and connection condition
- Damage, deformation, corrosion, or disconnection of terminal
- If there is any malfunction, repair or replace the malfunctioning location.