PID/Data Monitor Table

-: Not applicable

PID

Unit/Operation

Data contents

Module control terminal

AFS_ST ⁽⁷⁾

Off/On

Off: Adaptive front lighting system (AFS) is not operated
On: Adaptive front lighting system (AFS) is operated

AT_MAN_M_ SW

Off/On/Reserved/Unknown

Off: Selector lever is not in M position.
On: Selector lever is in M position.
Reserved: -
Unknown: M position switch signal is not determined.

AT_S_DWN_SW

Off/On/Reserved/Unknown

Off: Selector lever is not in shift-down position (-).
On: Selector lever is in shift down position (-).
Reserved: -
Unknown: Down switch signal is not determined.

AT_S_UP_SW

Off/On/Reserved/Unknown

Off: Selector lever is not in shift up position (+).
On: Selector lever is in shift up position (+).
Reserved: -
Unknown: Up switch signal is not determined.

BSM/RVM_SW ⁽¹⁾

Off/On

Off: Blind spot monitoring (BSM) OFF switch is off.
On: Blind spot monitoring (BSM) OFF switch is on.

DIM_CSW ⁽²⁾

Off/On

Off: Dimmer cancel switc is off.
On: Dimmer cancel switc is on.

DSC_OFF_SW

Off/On

Off: TCS OFF switch (without OFF-road Traction Assist)/OFF-road Traction Assist switch (with OFF-road Traction Assist) is off.
On: TCS OFF switch (without OFF-road Traction Assist)/OFF-road Traction Assist switch (with OFF-road Traction Assist) is on.

FUEL_GAUGE⁽³⁾

Displays fuel level detected by the fuel gauge.

FUEL_SEN_M

ohm

Displays fuel gauge sender unit resistance value.

NOTE:

Displays in the M-MDS but it does not operate.

FUEL_SEN_S⁽⁴⁾

ohm

Displays fuel gauge sender unit (sub) resistance value.

NOTE:

Displays in the M-MDS but it does not operate.

I_ILLUMI_M

Off (Day)/On (Night)

Off (Day): TNS (parking lights) switch is off.
On (Night): TNS (parking lights) switch is on.

I-ST_OFF_SW

Off/On

NOTE:

Displays in the M-MDS but it does not operate.

LDWS_ON_SW ⁽⁵⁾

Off/On

Off: LDWS switch is off.
On: LDWS switch is on.

MULTI_SW_ST

O.K./FAULT

O.K.: Cluster switch is normal.
FAULT: Cluster switch is malfunctioning.

ODO_CNT

km, ft, mi

Displays rolling count of the odometer

P_BRAKE_SW⁽²⁾

Off/On

Off: Electric parking brake switch is pressed.
On: Electric parking brake switch is pulled up.

PCONSW⁽²⁾

Displays the brightness of the illumination lights

R_GEAR_SW

Off/On

NOTE:

Displays in the M-MDS but it does not operate.

R_LMP

Off/On/Unknown/Fault

Off: Selector lever is not in R position
On: Selector lever is in R position
Unknown: Back-up light signal is not determined.
Fault: Back-up light malfunction

SPEEDOMTR

KPH, MPH

Displays vehicle speed

TACHOMTR

RPM

Displays engine speed

TM_CLPOS ⁽²⁾

2Positions/P/R/N/D/S (2)/L (1)/-

Displays the selector lever position

TOTAL_TIME

hh:mm:ss

Displays cumulative elapsed time since vehicle completion

TPMS_CAL_SW ⁽⁶⁾

Off/On

Off: Tire pressure monitoring system (TPMS) set switch is off.
On: Tire pressure monitoring system (TPMS) set switch is on.

TPRE_LMOD ⁽⁶⁾

Normal/Error

This PID indicates supply voltage (wheel unit No. 4).

VPWR

Displays power supply voltage

WU1_ERR_P ⁽⁶⁾

Normal/Error

This PID indicates tire pressure status (wheel unit No. 1).

WU1_ERR_T ⁽⁶⁾

Normal/Error

This PID indicates tire air temperature status (wheel unit No. 1).

WU1_ID ⁽⁶⁾

HexData

This PID indicates registered wheel unit ID (wheel unit No. 1).

WU1_P ⁽⁶⁾

KPa, MPa

This PID indicates tire pressure (wheel unit No. 1).

WU1_T ⁽⁶⁾

°C, F

This PID indicates tire air temperature (wheel unit No. 1).

WU1_VPWR ⁽⁶⁾

Normal/Error

This PID indicates supply voltage (wheel unit No. 1).

WU2_ERR_P ⁽⁶⁾

Normal/Error

This PID indicates tire pressure status (wheel unit No. 2).

WU2_ERR_T ⁽⁶⁾

Normal/Error

This PID indicates tire air temperature status (wheel unit No. 2).

WU2_ID ⁽⁶⁾

HexData

This PID indicates registered wheel unit ID (wheel unit No. 2).

WU2_P ⁽⁶⁾

KPa, MPa

This PID indicates tire pressure (wheel unit No. 2).

WU2_T ⁽⁶⁾

°C, F

This PID indicates tire air temperature (wheel unit No. 2).

WU2_VPWR ⁽⁶⁾

Normal/Error

This PID indicates supply voltage (wheel unit No. 2).

WU3_ERR_P ⁽⁶⁾

Normal/Error

This PID indicates tire pressure status (wheel unit No. 3).

WU3_ERR_T ⁽⁶⁾

Normal/Error

This PID indicates tire air temperature status (wheel unit No. 3).

WU3_ID ⁽⁶⁾

HexData

This PID indicates registered wheel unit ID (wheel unit No. 3).

WU3_P ⁽⁶⁾

KPa, MPa

This PID indicates tire pressure (wheel unit No. 3).

WU3_T ⁽⁶⁾

°C, F

This PID indicates tire air temperature (wheel unit No. 3).

WU3_VPWR ⁽⁶⁾

Normal/Error

This PID indicates supply voltage (wheel unit No. 3).

WU4_ERR_P ⁽⁶⁾

Normal/Error

This PID indicates tire pressure status (wheel unit No. 4).

WU4_ERR_T ⁽⁶⁾

Normal/Error

This PID indicates tire air temperature status (wheel unit No. 4).

WU4_ID ⁽⁶⁾

HexData

This PID indicates registered wheel unit ID (wheel unit No. 4).

WU4_P ⁽⁶⁾

KPa, MPa

This PID indicates tire pressure (wheel unit No. 4).

WU4_T ⁽⁶⁾

°C, F

This PID indicates tire air temperature (wheel unit No. 4).

WU4_VPWR ⁽⁶⁾

Normal/Error

This PID indicates supply voltage (wheel unit No. 4).

⁽¹⁾	With blind spot monitoring (BSM) system

⁽²⁾	If equipped

⁽³⁾	With instrument cluster (Type B or C)

⁽⁴⁾

AWD

⁽⁵⁾	With lane departure warning system (LDWS)

⁽⁶⁾	With tire pressure monitoring system (TPMS)

⁽⁷⁾	With adaptive front lighting system (AFS)