LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2023 >> CX-30 Preferred >> Repair and Diagnosis >> Electrical >> Horns >> Instrumentation/Driver Info >> Mazda EMERGENCY ASSISTANCE CONTROL MODULE REMOVAL/INSTALLATION

Mazda EMERGENCY ASSISTANCE CONTROL MODULE REMOVAL/INSTALLATION

  1. Disconnect the negative battery terminal.
  2. Remove the following parts:
    1. Passenger-side front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Passenger-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
    3. Passenger-side decoration panel (See DECORATION PANEL REMOVAL/INSTALLATION .)
    4. Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION .)
    5. Dashboard under cover (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION .)
    6. Passenger-side lower panel
  3. Remove the hose.
    G13750854Courtesy of MAZDA MOTORS CORP.
  4. Remove the bolts.
    Fig 1: Mazda Emergency Assistance Control Module And Bolts With Torque Specification
    G15658762Courtesy of MAZDA MOTORS CORP.
  5. Move the Mazda EMERGENCY ASSISTANCE control module in the direction of the arrow shown in the figure.
  6. Disconnect the connectors.
    G15658763Courtesy of MAZDA MOTORS CORP.
  7. Remove the wiring harness clip.
    G15658764Courtesy of MAZDA MOTORS CORP.
  8. Remove the Mazda EMERGENCY ASSISTANCE control module.
  9. Install in the reverse order of removal.
  10. If the Mazda EMERGENCY ASSISTANCE control module is replaced, perform the following procedure.
    1. Switch the ignition ON (engine off) to complete global central configuration (GCC) for the Mazda EMERGENCY ASSISTANCE control module.
    2. Clear the DTC. (See CLEARING DTC .)
scientia non olet · About LEMON Manuals