Off-Vehicle Inspection: Notes
WARNING: This page is about a different variant/trim than selected.
- Remove the TFT sensor. (See TRANSMISSION FLUID TEMPERATURE (TFT) SENSOR REMOVAL/INSTALLATION .)WARNING:
- A hot the transmission and ATF can cause severe burns. Turn off the engine and wait until they are cool before replacing ATF.
- Place the TFT temperature sensor in the container filled with ATF, and measure resistance between solenoid valve connector (coupler component) terminals A and B by gradually increasing the ATF temperature as shown in the illustration.
- If there is any malfunction, replace the TFT sensor. (See TRANSMISSION FLUID TEMPERATURE (TFT) SENSOR REMOVAL/INSTALLATION .)