Oil Hose No. 5 (Radiator Side) Installation Note

WARNING: This page is about a different variant/trim than selected.

Align the oil hose marking with the projection on the radiator and insert the oil hose into the radiator pipe installation area until it is abutted.

Courtesy of MAZDA MOTORS CORP.
The marks on the hose are within range A shown in the illustration.
If the hose does not insert easily, use ATF as a lubricating agent.
Wipe off the ATF remaining on the hose and pipe after installing the hose.
The hose clamp is within the marked area of the hose.

Courtesy of MAZDA MOTORS CORP.
CAUTION:
- If reusing the hose, install the new hose clamp exactly on the mark left by the previous hose clamp.
The hose clamp installation direction is within range B shown in the illustration.
Install the hose clamp onto the hose. Then apply force to the hose clamp in the direction of the arrow in order to fit the clamp in place.

Courtesy of MAZDA MOTORS CORP.
Verify that the hose clamp does not interfere with any other components.