DTC C1036-13: Electric Vacuum Pump Relay 2 - Stuck Off [EVP Control Unit]: Notes

DTC C1036-13: (EVP CONTROL UNIT) DETECTION CONDITION AND POSSIBLE CAUSE

DTC	C1036:13	Electric vacuum pump relay 2: stuck OFF
DETECTION CONDITION		EVP control unit terminal E voltage is 1 V or more for a continuous 0.2 s when electric vacuum pump relay 2 is turned on.
FAIL-SAFE FUNCTION		Refer to "Fail-safe function table". (See DTC TABLE [EVP CONTROL UNIT] .)
POSSIBLE CAUSE		Electric vacuum pump relay 2 (built-into EVP control unit) stuck OFF Electric vacuum pump relay 2 drive monitor circuit malfunction EVP control unit malfunction
SYSTEM WIRING DIAGRAM		-