DTC C1035-12: Electric Vacuum Pump Relay 1 - Short To Power Supply [EVP Control Unit]: Notes

DTC C1035-12: (EVP CONTROL UNIT) DETECTION CONDITION AND POSSIBLE CAUSE

DTC	C1035:12	Electric vacuum pump relay 1: short to power supply
DETECTION CONDITION		EVP control unit terminal C voltage is 90% or more of the battery voltage for a continuous 0.5 s when electric vacuum pump relay 1 is turned off.
FAIL-SAFE FUNCTION		Refer to "Fail-safe function table". (See DTC TABLE [EVP CONTROL UNIT] .)
POSSIBLE CAUSE		Electric vacuum pump relay 1 (built-into EVP control unit) stuck ON Short to power supply circuit in electric vacuum pump relay 1 (built-into EVP control unit) circuit Electric vacuum pump relay 1 (built-into EVP control unit) circuit malfunction EVP control unit malfunction
SYSTEM WIRING DIAGRAM		-