Using the M-MDS
- Connect the M-MDS to the DLC-2.
- After vehicle identification, select the following from the M-MDS initialization screen.
- Select "DataLogger".
- Select "Modules".
- Select "IC".
- Using the simulation function SPEEDOMTR, verify that the values are as indicated in the table.
SPEEDOMETER DISPLAY SPECIFICATION
| M-MDS display | Speedometer display |
|---|---|
| Off | Speedometer needle moves to approx. 0 km/h {0 mph}. |
| 60 km/h | Speedometer needle moves to approx. 57-63 km/h {36-39 mph}. |
| 120 km/h | Speedometer needle moves to approx. 116-124 km/h {72.1-77.0 mph}. |
- If not as indicated in the table, replace the instrument cluster. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)