DTC Inspection [Electrical Supply Unit (ESU)]
- Connect the M-MDS to the DLC-2.
- After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
- Select "Self Test".
- Select "All CMDTCs".
- Verify the DTC according to the directions on the screen.
- If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection. (See DTC TABLE [ELECTRICAL SUPPLY UNIT (ESU)] .)
- After completion of repairs, clear all DTCs stored in the electrical supply unit (ESU). (See CLEARING DTC [ELECTRICAL SUPPLY UNIT (ESU)] .)