LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2022 >> CX-5 Turbo Signature >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (On-Board Diagnostic - Engine Control System (VIN M) (3 Of 7)) >> DTC P0461-00: Fuel Gauge Sender Unit Circuit Range/Performance Problem >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.
DTC P0461-00: (PCM, VIN M) DIAGNOSTIC PROCEDURE

STEP INSPECTION RESULTS ACTION
1 RECORD VEHICLE STATUS AT TIME OF DTC DETECTION TO UTILIZE WITH REPEATABILITY VERIFICATION
NOTE:
  • Recording can be facilitated using the screen capture function of the PC.
  • Record the FREEZE FRAME DATA/snapshot data on the repair order.
 - Go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT FUEL GAUGE SENDER UNIT
 Yes Replace the fuel gauge sender unit, then go to Step 5.
(See FUEL PUMP UNIT DISASSEMBLY/ASSEMBLY [VIN M] ).
No Go to the next step.
4 INSPECT INSTRUMENT CLUSTER
 Yes Replace the instrument cluster, then go to the next step.
(See INSTRUMENT CLUSTER REMOVAL/INSTALLATION ).
No Go to the next step.
5 VERIFY DTC TROUBLESHOOTING COMPLETED
  • Always reconnect all disconnected connectors.
  • Clear the DTC from the PCM memory using the M-MDS. (See CLEARING DTC ).
  • Start the engine and warm it up completely.
    CAUTION:
    • While performing this step, always operate the vehicle in a safe and lawful manner.
    • When the M-MDS is used to observe monitor system status while driving, be sure to have another technician with you, or record the data in the M-MDS using the PID/DATA MONITOR AND RECORD capturing function and inspect later.
  • Drive the vehicle under the snapshot data condition.
  • Perform the Pending Trouble Code Access Procedure. (See ON-BOARD DIAGNOSTIC TEST ).
  • Is the PENDING CODE for this DTC present?
 Yes Repeat the inspection from Step 1.

Go to the next step.
No Go to the next step.
6 VERIFY AFTER REPAIR PROCEDURE
 Yes Go to the applicable DTC inspection.
(See DTC TABLE ).
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals